Read Aloud the Text Content

This audio was created by Woord's Text to Speech service by content creators from all around the world.

Text Content or SSML code:

THIS VIDEO IS PRESENTED BY S AND L AEROSPACE. IN THIS VIDEO, WE WILL SHOW YOU HOW TO LOAD A PART INTO A CNC MACHINE. USE AN AIR BLOWER TO BLOW THE COOLANT ON THE SURFACE OF THE FIXTURE, CLEAN THE FIXTURE AND ENSURE THERE ARE NO CHIPS LEFT. A SMALL CHIP WILL CAUSE A PROBLEM WITH THE FLATNESS OF THE ENTIRE PART. LOAD THE CYLINDER PART FROM THE TOP OF THE FIXTURE BY FOLLOWING THE SET-UP SHEET, THE POSITIONING END FACE DONE. SLICE THE PART DOWN SLOWLY. TARGET THE LOCATION PIN TO THE POSITIONING HOLE. TWO CLAMPS ARE HOLDING THE PART ON THE BOTTOM SIDE. APPLY LOCKING BOLTS EVENLY.